MAXTER: Article

Sles of Blow -Gun

You can use lighter gas to ensure a sift animal injection and compress air with the normal injector(20-30cc) without any separate tool.
Gas type and air compression type are used parallel.

Parts Description
Kinds of animal Injectiors

	3cc,3.5cc : Shot with the barrel of 12.5mm caliber 11mm latex string 20mm effective range 25mm maximum range 15mm latex sting 30mm effective range 40mm maximum range
	4cc : shot with the barrel of 16.5mm caliber 15mm latex string 25mm effective range 35mm maximum range
	6cc: shot with the barrel of 116.5mm caliber 15mm latex string 30mm effective range 40mm maximum range
	10cc: shot with the barrel of 16.5mm caliber 20mm efective range 30mm maximum range
	Blow gun injector: parallel use of gas compressionn type and air compressionn type

How to compress Animal injectors
Insert the nomal injector with 20-30cc capacity behind the animal injector and secure the
space for drug injection ->inject drug with the small injector and insert the injector needle for commpression.->drew out the animal injector in the state of strong compression by the normall injector.
In order to make commpression stronger, it is effective to commpress using a needle as thick as blow-gun one. when the rubber bucking sill not move, it is okay to push it with wire, etc.
The gas compressionn type is completed by inserting the injector neddle at the lighter gas cask in to the animal injector, inject the fluid gas and the draw out the animal injector.
In case of gas injection, it is effective using the rubber for bicycle to prevent leakage..
The state of compression is maintained about 40-50 minutes.
In case of over 3cc drug injection, it is quick and powerful to use the gas type.

Types and Parts of the Animal syringe

Compression Method and usage of the Animal Syringe Arrow
1. the method on the right is a gas filling method. by putting a disposable syringe needle through the latex rubber to the compression room, and fill the liquid gas as in the picture. If gas in the form of water drops is observed in the lower part of the syringe arrow, the commpression is completed, wihich will last for about two hours. The gas filling method is twice stronger than an air commpression method in the propulsive fore. Therefore, a lot of injection liquild is inserted instantaneously. Moreover ther is an advantage that shooting can be made while commpression is checked with the naked eye.
2. The mothod on the left is a air compression method. By pricking a 30cc syringe in the back part of an arrow, and pumping it more than 7-8 times, compress the air. After this, check its compressionn state by putting it in a cup filled with water, and it theh are compression is confirmed, shoot it. the duration o the aire compression is about 24 hours to 48hours. This method is normally used when the gas method is impossible.

when applying any of the two aforemetioned method, the following should be kept. Open the upper part of a sying, and inser dugstuff in it. Close the pug, and push the moveable packing to the end of the upper part by a push stick. After closing the back part, use it.